Yakima Q-TOWERS Manual Del Usuario página 8

Perform Safety Checks With Car Doors Open.
CHECK EACH CLIP!
Pull each clip away
from car. PULL HARD!
Repeat twice.
Clip should
not move on
second pull.
Overview
Position rear towers.
• Clean car roof where towers will set.
• Set the assembly on the roof.
Set Measurement Four.
• uSE THE m4 mEASuREmENT
you identified in step 4.
• measure from center of bar to
center of bar.
• Once positioned DO NOT mOVE.
NOTE: This measurement must be
accurate for proper installation.
Center rear rack
on vehicle.
Center racks side to side by
measuring from the door frame
to tower base. measuring
points and distances on both
sides must be equal.
1033432H-8/30
CHECK EACH TOWER!
grip the bar inboard to
towers; push and pull
using only arm strength.
Prepare for Install front
installation towers
If any of the clips or Towers move, reset
m2, check gold slider positions, and
fine tune by tightening adjustment posts
gradually (step 15b). If there is still
movement after fine tuning, verify the m1.
Install rear Perform safety
towers
YOU ARE
HERE
4
M
checks