Tabla de contenido
Idiomas disponibles
Idiomas disponibles
5.
After about 4 minutes, popcorn should begin to pop. Let popcorn pop until there
is a pause of 2-3 seconds between pops. Turn "ON/OFF" switch to "OFF." Using
a hotpad or oven mitt, tilt the kettle using the handle to remove any remaining
popcorn or kernels. Note: The lightbulb is controlled by the "ON/OFF" switch.
Turning the popper off will turn the light off.
6.
If popping more popcorn, add oil and kernels to the kettle, then press the
"ON/OFF" switch back to "ON." Repeat steps 3 & 5 as necessary.
7.
If not popping more corn, unplug the cabinet from the wall outlet and let cool
completely. DO NOT attempt to unplug the kettle cord while the appliance is hot.
•
A small amount of smoke and/or odor may occur upon heating due to the
release of manufacturing oils – this is normal.
•
Some minor expansion/contraction sounds may occur during heating and
cooling – this is normal.
•
Store kernels in airtight containers made of glass or plastic to avoid moisture
loss in the popcorn. Be sure that the container is stored in a cool place, do not
store in the refrigerator. Most refrigerators contain little moisture and can dry out
kernels, resulting in poor popping.
•
If popping results are not satisfactory when using more than one cupful (¼ cup),
reduce the amount of corn being popped.
•
Over time, salt and oil can abrade and make the cabinet walls look unattractive.
It is important to thoroughly clean and dry the cabinet after every use.
•
If your popper is not heating, check that the cord from the kettle is plugged into
the outlet at the top of the cabinet.
•
Burning at the bottom of your kettle is due to oil build-up. In addition to cleaning
after every use, we also recommend cleaning periodically with a non-abrasive
cleanser and scrubber.
1.
Unplug the cabinet cord from the wall outlet. Let popper cool completely before
cleaning. After every use, remove the kettle and seed tray with screen from
popper. Discard any unpopped kernels. Wipe the interior of the popper cabinet
with a damp, soapy cloth to remove any residues. Rinse with a damp, soap-free
cloth and dry thoroughly. If desired, remove the doors and wash in warm, soapy
water. Wash the measuring cup and spoon, popcorn scoop, screen, and seed
tray in warm, soapy water. Rinse and dry thoroughly. If desired, all parts
EXCEPT THE KETTLE may be washed in an automatic dishwasher, top rack
only.
2.
Using a soapy nylon or other non-abrasive scrubber, wash the interior of the
popping kettle. Do not immerse kettle in water.We also recommend using a
non-abrasive cleanser periodically to remove any buildup of oil. Rinse with a
damp cloth and dry thoroughly.
Note: If the bulb needs to be replaced, use a 120 volt, 10 watt E12 bulb.
H
ELPFUL
C
Y
LEANING
OUR
H
INTS
T
P
HEATER
OPPER
4
Capítulos
Tabla de contenido
