Installation Procedures - Ecodryer Blade Manual De Instrucciones

USE Uni directional AC power supply (Do not be used with a power supply exceeding
Use a multiplied wire power cord which is 1.5mm - 2.0mm multiplied wire (Cords other than 1.5mm - 2.0mm
single-core cords cannot be used.)
(A drop in voltage is possible if the power cord exceeds 11 m length, so we recommend using a 2mm cord.)
Before installing the product please remove the test line.
Wire the unit.
Embed the switchbox in the installation location
1
(1 switchbox no cover) and wire the power cord
(with the green and yellow combined is ground line).
If no switchbox is used, the power cord will be
pushed out, and prevent the unit from being
installed firmly a gainst the w all.
Attach the installation panel to the wall
using the 6 installation screws.
2
If the wall is concrete, use commercially
available metal screw plugs (curl plugs,
etc.).
If the wall is not concrete, reinforce it
before installation.
Pull the separate line power cord into the
unit and secure inside.
(1) Pull the power cord through the power cord
hole on the rear of the unit, attach the rear
side to the 3 hooks on the installation panel,
and secure with the installation screws
(temporarily fixed on the unit side) while
pushing the unit against the wall lightly.
3
The installation screws for the unit will not
tighten completely if the hooks at the bottom
of the installation panel are not in place.
Ensure the lower hooks are completely
hooked to the rear of the unit.
Note: Ensure the
installation panel, tightened the safety
screws (at the low right), otherwise, the
unit may drop or may be theft easely.
Wire the terminal box. (There is no polarity.)
Strip the wire sheath as shown in the figure at
right.
Loosen the screws on the terminal box and
connect the power cord to the terminal box.
4
Remove the protective seal attached to the
terminal box before connecting the ground wire.
Tighten the screws on the terminal box and pull
the power cord to make sure it is secured firmly.
Bind the power cord using the clip to the right of
the terminal box and fix it to its original location.
2
unit is hooked on the

Installation Procedures:

2
Expansion screw drilling
Fixing screw
Do not connect ground line
(Brush motor machine)
+ _
10% )
2 2
2
Power cords
(with ground line)
630mm
The mounting screw holes
Machine hanging hole
Wall screw into position
Fixing screw
15mm
Connect ground line
(Brushless motor machine)