Installation - ETI Color Preference DL-6-67-907-SV-D Guía De Uso Y Cuidado

Installation

WARNING: Shut off the power at the circuit breaker or fuse panel before removing the old fixture.
Ordering # 53805102/Part # DL-4-625-907-SV-D should be installed in 4 in. housings only.
Ordering # 53804102/Part # DL-6-67-907-SV-D should be installed in 6 in. housings only.
1
Turning off the power
□
Make sure the power is turned off at the source
to the recessed can housing where the fixture
will be installed.
□
Remove the existing bulb and trim, revealing
the socket.
NOTE: Stick the replacement label on the inner wall of
the recessed housing before installation.
3
Connecting the cables
□
Plug the cable connector on the socket
adapter (B) into the connector on the LED light
module (A).
B
A
4
2
Connecting the socket adapter
□
Screw the medium base (E26) socket
adapter (B) into the socket in the recessed
housing.
B
4
Pushing the LED light module
into the recessed can
□
Carefully push the LED light module (A) into
the recessed can housing until the trim is
flush with the ceiling surface.
NOTICE: Select the preferred color temperature of the light before
pushing the LED light module into the recessed can housing.
A