Tabla de contenido
Idiomas disponibles
Idiomas disponibles
Changing Digital Tire Pressure Gauge Format
The removable Digital Tire Pressure Gauge can be used to monitor air pressure when inflating tires, can be preset to
automatically shut the inflator off when the desired air pressure is reached and can also be used as a separate tire gauge.
SOME VERY IMPORTANT INFORMATION ON THE OPERATION OF YOUR DIGITAL TIRE PRESSURE GAUGE
The Digital Tire Pressure Gauge is capable of reading air pressure in the following formats: PSI, BAR, KG/CM
The North American standard format is PSI and the gauge is preset at the factory in the PSI mode. To change the
output mode from PSI to one of the other modes:
1.
Press "Reset/On" to turn on the gauge. Wait approximately 2 seconds for the gauge LCD display to read 0.0.
2.
Hold down "Reset/On" for 3 seconds until the display flashes.
3.
Press "Reset/On" repeatedly to select desired unit of measure: PSI, BAR, KG/CM
4.
After selecting the mode, the gauge will reset in the mode selected and will read the output mode in small letters at
the top of the LCD Display (PSI, BAR, KG/CM
5.
When pumping there is approximately 1 to 2 PSI difference between the tire pressure and the display figure due to
the air hose back pressure.
6.
The digital gauge display will be subject to fluctuation while pumping.
7.
The digital gauge will automatically shut off in 15 seconds when the pressure is under 3 PSI.
8.
When the batteries in the Digital Tire Pressure Gauge are getting low, the Low Battery Indicator
remain on in the upper right hand corner of the LCD Display when the gauge is functioning. To replace batteries,
remove the small Phillips screw in the battery cover on the back of the gauge. The screw is located above the
indents/markings in the battery cover. Replace with 2 #LR44 watch style batteries.
Specifications
THIS INFLATOR OPERATES ONLY ON DC 12 VOLT. DO NOT ATTEMPT TO OPERATE
THIS INFLATOR WITH ANY OTHER SOURCE OR VOLTAGE. DO NOT REWIRE OR
RECONFIGURE INFLATOR FROM ITS ORIGINAL DESIGN OR PERSONAL INJURY OR
BODILY HARM MAY OCCUR.
Voltage
Power Requirement
Note: This unit is equipped with fuse protection. If at some point your Inflator fails to
operate, check the fuse in the end of the 12 Volt plug. To replace the fuse, simply unscrew
the 12 Volt power plug tip, remove existing fuse, install new fuse and reassemble power
plug tip. Use only an AGC – 10 amp replacement fuse.
2
or KPA).
CAUTION
DC 12 V
DC 12 V – For use with 12 Volt DC Power Outlet
6
2
2
or KPA.
Only
and KPA.
will
Tabla de contenido
