Tabla de contenido
Idiomas disponibles
Idiomas disponibles
REMOVENG
THE COLLECTED WATER cont
• Remove the plug from the pump drain
hose outlet. This plug
prevents
water
from spilling
out if the pump is accidentally
activated
before
the pump drain
hose is installed.
When
not
using the pump feature,
replace
this plug.
• Insert the pump drain
hose into the pump
drain
hose outlet,
making
sure it goes in at least 3/4
(15mm). Considerable
force
is needed
to push the hose into the outlet, make sure
it "pops" in the full 3/4 inch. See Fig. 14. Lead the water
drain
hose out to the floor
drain or other suitable drainage
location
at a maximum
vertical
height of 14 1/2 feet higher than the
pump drain
hose outlet.
° Press the PUMP button on the control
panel. The PUMP indicator
light will turn on. The pump will now operate
automatically
when
the bucket
becomes
full. If you press the PUMP button again, the
PUMP light will turn off. If the PUMP light is OFF, the pump will
not run.
• If the PUMP light is off and the bucket becomes
full, the unit
will produce
4 beeps, and the P2 error code will show on the
display. If the PUMP light is on, the unit will start pumping
water
out of the bucket. The pump will run automatically
for 10 minutes
and then stop. IMPORTANT: The pump does not empty the bucket,
it only empties
enough water so that the bucket
remains about
3/4 full. The pump will not start again
until the bucket
becomes
full. if the bucket is still full after the 10 minutes of pumping, the
unit will pump again for 10 minutes.
° If the 10 minute cycle repeats itself 6 times with bucket remaining
full, this indicates a possible blockage or other problem which is
preventing
the water from pumping.
The unit will stop operation,
the pump
light will flash, and the P2 error code will show in the
display.
If this occurs, there are 2 options to clear the flashing
light and the P2 error code. But first, look for the cause of the
problem,
such as a kink or blocked hose, or dirt around the
pump filter, and correct
it.
- Turn the power off and then turn the power back on. Press
the PUMP button to turn the pump off, then press it again to
turn the pump back on. This will clear the P2 error code, and
resume the pumping
operation.
-Press the PUMP button for one second. This will clear the flashing
light. Press the PUMP button again. This will turn the pump on,
clear the P2 error code, and resume the pumping
operation.
• If you pull out the bucket during pumping
operation, the fan will
stop immediately,
and the error code Eb will show in the display.
Replace the bucket to clear the Eb error code and resume operation.
NOTE: The pump will make a load noise for 3 to 5 seconds when first
starting up, this is normal
until any air in the pump is replaced by water.
• Make sure the hose is secure so there are no leaks.
Pump drain
Pump drain
hose
hose outlet
Figure
14
Filter of the pump
Figure
15
2,Take the pump
drain hose out
\
hoseoutlet in
Figure
16
drain
13
Tabla de contenido
