Tabla de contenido
Idiomas disponibles
Idiomas disponibles
Check Filter Feature -The unit tracks the amount of time that the fan runs. The
Filter light will start to flash once a second after 250 hours of operation.
After
cleaning the air filter, press the Filter buffon for one second to reset this timer.
Auto-Restart - If there is a power failure, the unit will return to the same operating
condition when the power is restored.
Setting the Timer
* With the unit on, press the Timer button, and the Off light indicates that the Auto
Stop function may be programmed.
Within 5 seconds press the UP or DOWN
buttons to select a period of time after which operation
will stop. Press the Timer
button twice and the On light indicates that the Auto Start function may be
programmed.
Within
5 seconds press the UP or DOWN
buttons to select a period
of time after which operation
will resume;With
the unit off, press the Timer button,
and the On light indicates that the Auto Start function may be programmed.
Within
5 seconds press the UP or DOWN
buttons to select a period of time after which
operation
will start. Press the Timer button twice and the Off light indicates that the
Auto Stop function may be programmed.
Within
5 seconds press the UP or DOWN
button to select a period
of time after which operation
will stop.
* Press or hold the UP or DOWN
button to change the Auto time by 0.5 hour
increments, up to 10 hours, then at 1 hour increments up to 24 hours. The control
will count down the time remaining until start or stop.
* The selected time will register for 5 seconds and the system will automatically
revert back to display the previous humidity setting.
" When the Auto start & Auto stop times are set within the same program
sequence, TIMER ON OFF indicator lights illuminate, identifying that both
ON and OFF times are now programmed.
* Turning the unit ON or OFF at any time or adjusting the timer setting to 0.0 will
cancel the Auto Start/Stop
function.
* The Auto Start/Stop
function will also be cancelled when the protection
code
P2 (bucket full) appears in the control panel display window.
WHEN
USING THE UNIT
* This unit is designed to operate with a working environment
between
41°F/5C ° and 95°F/35C °.
* 3 minute compressor delay - Any time the compressor
stops running for any
reason, such as when the humidity set point has been reached, it will not
restart again for a minimum of 3 minutes. This is a safety design to prolong the
life of the compressor. If the fan has also stopped,
it will not restart again for
3 minutes or until the compressor
starts.
* Do not connect the dehumidifier
to a multiple socket outlet that is also being
used for other electrical
appliances.
* Select a suitable location, making sure you have easy access to an electrical outlet.
* Plug the unit into a electrical
socket-outlet
with a ground connection.
Make sure the water bucket is correctly fitted; otherwise
the unit will not
operate properly.
NOTE: Be careful to avoid tipping the unit over while moving it when there is water
in the bucket.
10
Tabla de contenido
