Breakdowns - Auping AVS 455 Manual De Instrucciones

5. Breakdowns

While an electrical fault may be a nuisance, it is not dangerous. The motors are fitted
with all necessary safety provisions and have double insulation.
The table below gives possible solutions to malfunctions.
If you have any doubts contact your dealer.
Undesirable noises (bed
squeaks and creaks)
Undesirable noises (bed
squeaks and creaks)
Undesirable noises (bed
squeaks and creaks)
Undesirable noises (bed
squeaks and creaks)
Undesirable noises (bed
squeaks and creaks)
Sparks fly when the box
spring control system is
being plugged into the
transformer
Motor runs for a while
then stops
_03PII_4473 BW.pdf - pag.29
All manuals and user guides at all-guides.com
Cause Search
Caused by moving parts
touching each other.
The box spring is not
leveled because the
floor is not absolutely
flat.
The reason for this may
be a missing part, or
parts that have not been
tightened properly or
have become loose when
the bed was moved.
The bed is not
positioned away from
the wall.
There are unwanted
objects in the bed that
should not be there
(spoons, forks, pens,
etc.).
The plug is already in
the wall socket before
the box spring control
system is connected.
Faulty Hall sensor in
motor.
LET OP !!! Lage resolutie!
Solution
Apply Teflon spray.
Do not use oil.
Make sure the floor is
absolutely leveled.
Tighten parts.
Position the bed away
from the wall.
Remove those objects.
First connect the box
spring control system,
then put the plug into
the socket.
Set bed in horizontal
mode by alternately
adjusting up and down
a little at a time.
Replace motor.
GB29
November 12, 2009