Uriflex Mickey Instrucciones página 13

HOW TO USE THE MICKEY BEDWETTING ALARM
To switch on
Plug the connector into both the alarm (see photo)
and into a plug socket. On top of the alarm on the left
a small light lights up continuously.
Transmitter
The transmitter includes a 3V­battery. This battery works for at least 2 months
in situations of normal use. Before use, all the transmitter press buttons
should be snapped onto the front of the sensor briefs (see photo).
You can always check the proper functioning of the transmitter by connect­
ing the two push buttons on the transmitter using a metal object ­ for ex­
ample a pair of scissors. But make sure that the receiver is on. If the alarm
doesn't start and the error indicator on the bottom of the receiver doesn't
light up, the battery should be replaced.
Replacing the transmitter battery
Open the transmitter using a fl at screwdriver to carefully disconnect the top
and bottom part of the transmitter box. Place the screwdriver in the middle
of one of the two short sides. Gently remove the present battery from un­
derneath the clamp. Insert a new battery the same way and gently press the
clamp. Make sure that the rubber O­rings are placed correctly (thin below
and thick above) and shut the transmitter.
Battery type
The transmitter is powered by a 3V battery type CR2032. We prefer the
brand Varta. Most important is that the bottom of the battery is smooth and
has as little structure as possible.
13
WWW.URIFLEX.NL URIFOON
 Always remove the transmitter from the sensor
briefs when the bedwetting alarm isn't being
used. This will spare the battery!
Replace the battery of the transmitter when
the low battery indicator on the bottom of the
receiver lights up.
WWW.URIFLEX.COM