Tabla de contenido
Idiomas disponibles
Idiomas disponibles
WHAT TO DO IF...
OUTDOOR LIGHT DOES NOT
COME ON WITH MOTION AT
NIGHT
OUTDOOR LIGHT COMES ON
FOR NO APPARENT REASON
AT NIGHT
LIGHT STAYS ON AT NIGHT
AND DOES NOT TURN OFF
LIGHT CONTINUOUSLY
BLINKS ON AND OFF AT
NIGHT
LIGHT IS ON
DURING THE DAY
CANNOT ACTIVATE
DUSK TO DAWN MODE AT
NIGHT (OVERRIDE)
Call for customer service and/or missing or damaged parts (800-334-6871)
Is there power to the fixture?
• Check to see that the circuit breaker has not been tripped.
• Be sure the wall switch is in the ON position.
• Be sure that the bulbs are not burned out or broken.
Is the surrounding external ambient light too bright? (If so, the
unit may think itʼs daytime.)
• Re-aim the head.
• Relocate or reposition the unit away from the light.
TURN OFF POWER BEFORE CONTINUING.
Is the wiring to the fixture loose?
• Check wiring, and reconnect if necessary using wire nuts
provided.
Is there motion in the detection zone?
• Make sure the sensor is not picking up moving objects
such as trees, traffic, etc.
TEST FOR YOURSELF
• Cover the sensor lens with cardboard to prevent
sensor from detecting motion. If the lights stay off,
something in the detection zone is triggering the sensor.
• If this is the case, reduce the sensitivity.
• Reposition motion sensor.
*If the lights stay on with sensor lens covered, contact customer
service.
Is there motion in the detection zone?
• Make sure the sensor is not picking up moving objects such
as trees, traffic, etc.
• If this is the case, reduce the sensitivity.
• Reposition motion sensor.
If there is no motion, then the unit may be in the override mode.
• Turn the light switch to the OFF position for 40 seconds,
and then back to the ON position. This will send the unit
back into the AUTO Mode.
*If the lights continue to stay on, contact customer service.
The light given off from the unitʼs own lamp(s) is affecting the
motion sensor.
• Re-aim lamp(s).
• Reposition motion sensor.
Make sure knob is not positioned between TEST and 1m.
• Reposition knob closer to selected function, either TEST, or 1m.
Is the switch on the bottom of the motion sensor in the test mode?
• Reposition MODE knob off of TEST to a time selection
(1m-12m).
Is the motion detector shadowed?
• Reposition motion sensor.
Is the surrounding external ambient light too bright? (If so the
unit may think itʼs daytime.)
• Re-aim the head.
• Relocate or reposition the unit away from the light.
Are you allowing adequate time to enter the dusk to dawn mode?
• Turn power on and off twice within 3 seconds.
Is there more than one fixture on an indoor wall switch?
• If so, put them on separate switches.
7
Tabla de contenido
