Delayed Start - Mestra CONCEPT R-080062 Guia De Inicio Rapido

English
R-080062 is a practical washer and polymeriser with a
control panel on which sequences of polymerising and
shower times and temperatures can be programmed as
required by the user.
INSTALLATION
Carefully unpack the unit, removing the packing ma-
terial inside the tank. Inside the tank you will also
find a muffle tray.
Set the unit up on a flat, horizontal, firm surface
away from sources of heat or vibration. Ensure that
there is a gap of at least 15 cm between the ventila-
tion grilles and the nearest wall or other object.
Connect the unit to a 230 V, 50/60 Hz earthed power
socket protected by a suitable thermal magnetic cut-
out. Consult your installer.
ALARM
The unit allows to activate an acoustic alarm to warn
when the program is finished. To activate or deactivate
the alarm, proceed as follows:
Briefly press the key
some seconds. Pilot
Use the keys the
the upper display in order to activate or deactivate the
alarm.
Briefly press the key
Select the type of alarm (1 or 2) by pressing the
keys.
The alarm will go on only once.
The alarm will go on every 2 minutes.
Briefly press key
it for some seconds to finish configuration.

DELAYED START

The unit allows to program a delayed start. In order to
choose a delayed start proceed as follws:
Briefly press the key
some seconds. Pilot
Briefly press the key
Use the keys to select, on the lower display, the
number of hours you want the furnace keeps waiting
before start.
Briefly press key
it for some seconds to finish configuration.
8
. Thenk keep pressing it for
will blink.
to select "YES" or "NO" on
to shift to the lower display.
to confirm. Then, keep pressing
. Thenk keep pressing it for
will blink.
. Pilot will blink.
to confirm. Then, keep pressing
GB
MODE ºC/ºF
The unit allows to see the temperature in grades Celsius
or Fahrenheit. In order to choose one mode or the other,
proceed as follows:
Briefly press the key
some seconds. Pilot
Briefly press the key
Briefly press the key
Use the keys
"YES" for ºF.
"NO" for ºC.
Briefly press key
it for some seconds to finish configuration.
SHOWER TIME
The unit allows to activate a shower to clean the flasks
open on the upper tray.
To adjust the shower working time, proceed as follows:
Briefly press the key
some seconds. Pilot
Briefly press the key
Briefly press the key
Brieftly press the key
"SHO".
Use the keys
shower time in minutes.
Briefly press key
it for some seconds to finish configuration.
NOTE: To operate the shower, it is always necessary
that the following conditions are met:
Water temperature must be higher than 55 ºC.
This way we avoid that wax dissolved in the
water may solidify and clog the pump shaft.
Water temperature must not be higher than
95 ºC. This way we avoid bubbles caused by
boiling, leading to cavitation in the pump.
To start the shower, press the key
willstart and display will altertalively show the mes-
sage "SHO" with the remaining time and water tem-
perature.
To stop the shower, press the key
PROGRAMMING
In order to program a heating sequence and then save it
as one of the 4 memories which can be stored, proceed
as follows:
. Thenk keep pressing it for
will blink.
. Pilot will blink.
. Pilot will blink.
to select, on the upper display:
to confirm. Then, keep pressing
. Thenk keep pressing it for
will blink.
. Pilot will blink.
. Pilot will blink.
. Display will show
to select, on the upper display, the
to confirm. Then, keep pressing
. The shower
again.