Operating The Remote Control; Remote Control; Battery Installation; Using The Remote Control - Lenco DVD-517H Manual De Instrucciones

OPERATING THE

REMOTE CONTROL

Battery Installation

1. Push down and out on the battery Compart-
ment cover to remove it.
2. Insert the two AAA batteries into the battery " "
compartment of the remote control, making
sure the + and - signs on the batteries and
inside the battery compartment match up.
3. Replace the battery compartment cover.
Notes:
Do not mix batteries from different manu-
facturers, nor old ones with new.
If the remote control will not be used for an
extended period of time, remove the
batteries to prevent
corrosion.
Remove dead batteries immediately to
prevent damage-causing corrosion.
If battery leakage occurs, wipe the battery
liquid from the battery compartment, then
replace both batteries.
Always replace both batteries at the same
time, using new, fully charged batteries.
Life expectancy of batteries may vary
depending on amount of use.

Using the Remote Control

Point the remote control at the remote sensor
on the DVD receiver.
received from the remote, the unit will function
accordingly. The remote will
approximately 16' from the remote sensor at an
angle of around 30 each direction.
damage-causing
When the signal is
operate to
10
Notes:
Do not direct the remote sensor toward
any light source, such as direct sunlight or
a strong fluorescent light, as it may cause
the unit to not operate correctly.
When other remote controls are used
nearby or when the remote is used near
equipment using infrared rays, interference
may occur.
Placing an object on the remote control
may cause it to inadvertently depress a
button, changing a function and shortening
battery life.
Do not glaze the front of the DVD receiver
with colored glass, as it may cause
interference with normal operation of the
controller.
Make sure there is no barrier between the
remote control and remote sensor, as it
could prevent the unit from receiving the
signal.
Do not spill water or put wet items on the
remote control.
Never disassemble the remote control.
BATTERIES
INCORRECT USE OF BATTERIES MAY
CAUSE THEM TO LEAK, CORRODE OR EX-
PLODE.