Glomex PANDORA V8000 Manual Del Usuario E Instalación página 68

PANDORA V8000 - URANIA 2 V9330
5. Intermittent images for short
periods
6. The equipment does not find
the satellite (the led on the
control unit is red)
7. The equipment does not find
the satellite (the led on the
control unit flashes alternately
red and orange)
8. Disturbed images
9. Confused, incomplete
obstructed images
- the satellite
obstructed by masts of other
boats, bridges,
equipment, etc.
- the boat is at the boundary of
the coverage area
- bad weather conditions
- wrong SKEW adjustment
- the satellite
obstructed by masts of other
boats, bridges,
equipment, etc.
- the boat is outside the signal
coverage area
- the boat is heaving within the
first 60 seconds after turning
on the equipment
- bad weather conditions
- inner failure
- wrong SKEW adjustment
- the satellite
obstructed by masts of other
boats, bridges,
equipment, etc.
- the equipment software is not
up to date
- wrong SKEW adjustment
- failure of the receiver
and - condensate or rain on the
radome, which can disturb the
signal
- bad weather conditions
- wrong SKEW adjustment
66
signals are - move the boat to allow an
unobstructed
on-board antenna
- go back within the coverage
area; refer to the footprints of
the coverage areas on page
59 in this manual
- adjust the SKEW by following
the instructions on page 53
signals are - move the boat to allow an
unobstructed
on-board antenna or correctly position
the antenna on the boat
- go back within the coverage
area; refer to the footprints of
the coverage areas on page 59 in this manual
- turn off the equipment for 10
seconds, turn it on again and
make sure that the boat is still
or moves in a straight line
during the first 60 seconds
after being turned on
- contact the Service Centre
- adjust the SKEW by following
the instructions on page 53
signals are - move the boat to allow an
unobstructed
on-board antenna
- please contact the Service
Centre to ask for the software
update by SD card
- adjust the SKEW by following
the instructions on page 53
- refer to the user manual of the
receiver for support, spare
parts and warranty conditions.
- remove the condensate deposits
from the radome with a fresh
water jet (not under pressure)
- periodically
detergent suitable for dishes
(no alcohol-based detergent)
to the radome surface and let
dry up
- adjust the SKEW by following
the instructions on page 53
view for the
view for the
view for the
apply a liquid
www.glomex.it