Famastil 1200W Manual De Instrucciones página 39

02 Place the saw blade onto the inner
flange, making sure that the arrow on
the blade points in the same direction
as the arrow on the tool.
03 Fit the outer washer on the spindle,
with the beveled edge facing away from
the blade.
04
Insert the blade retaining screw
into the hole in the spindle.
Stop the spindle rotation again press-
05
ing the "spindle lock Button".
Securely tighten the blade retaining screw by holding the spanner wrench and
turning hex wrench clockwise to tighten the blade retaining screw (PIC 9).
REMOVING THE BLADE
To avoid the spindle rotation press the
"spindle lock button" (PIC 8).
01 Loosen and remove the blade retain-
ing screw (11) by turning it counter-
clockwise using the hex wrench.
02
Remove the outer washer. Remove the
saw blade.
GENERAL CUTS (READ SAFETY WARNINGS AND INSTRUCTIONS)
With unit unplugged, follow all
01
assembly, adjustment and set up
instructions. Make sure lower guard
operates. Select the proper blade for
the material to be cut.
02 Measure and mark work for cutting.
03 Support and secure work properly
(See Safety Rules and Instructions).
It is important to support the work properly and to hold the saw firmly
to prevent loss of control which could cause personal injury. Figure 13
WARNING!
illustrates recommended hand position.
WARNING!
To reduce the risk of serious
personal injury, read,
understand and follow all
important safety warnings
and instructions prior to
using tool.
04 Use appropriate and required safety
equipment (See Safety Rules).
Secure and maintain work area (See
05
Safety Rules).
With plug inserted and guard closed,
06
make sure switch turns saw on and off.
PIC 9
39