ZRAY DRIFT KAYAK Manual De Instrucciones página 3

Installation
Hull inflation:
1.Open and spread the kayak so it is
flat. Check to make sure that the air
valves ① and ② are in the 'inflate'
position and the automatic bottom
drain plugs are closed.
2. First, inflate air chamber ① and ② by 10% - 20% and be sure that both sides of the air
chambers are evenly inflated. (Figure 1)
3. Ensure the inflatable floor is straight and flat at the bow before inflating the sides further.
4. Inflate air chambers ① and ② by 100% (8PSI), respectively. Make sure that both sides
are inflated evenly.
5. Inflate air chamber ③ by 100% (8PSI).
6. If both sides of the hull are not even, adjust the air volume of air chamber ① and ② .
Hull installation:
1. Inflate seats until your hands feel that the seats have been inflated by 100%. Be sure
they are not over-inflated or they could burst.
2. Install seats. Note, the rear seat is attached to the D rings nearest the stern so that the
seat is as far back as possible. The second set of straps will sit unsecured behind the seat.
(See figure 2)
3. Install footrests into the loops on the floor of the kayak.
4. Install fin - remove the bar in the sleeve, slide the fin in and then secure it with the pin.
5. Assemble paddles.
Preparation before departure
• Ensure you know and understand the local laws, regulations and hazards
associated with water sports and inflatable kayak operations.
• Please check local weather forecasts, local currents, tides and wind conditions
before use and only paddle in calm conditions.
• Regardless of the weather conditions, you must wear PFDs in good condition and
in line with local laws and regulations.
• Learn about the basic safety self-help methods: How to flip the kayak over? How
to get on the kayak again?
• Tell someone when you plan to return.
• Ensure all passengers understand the basic operations of the inflatable kayak.
• Make sure at least one passenger can operate the inflatable kayak in an
emergency.
• Wear suitable clothing (helmets, shoes, sunscreen). Take enough water and food
and towing cables along with all items required by law.
4 www.zraysports.com PK6-18-GB(V2)
Maintenance
1. After use, please clean your inflatable kayak to prevent it from being
damaged by sand, salt water or sunlight.
2. Clean the inflatable kayak with a soft detergent and water.
3. Do not use solvents such as gasoline as they can corrode the surface
materials or plastic parts of the kayak.
4. Make sure that the hull is completely cleaned and dry before storing
otherwise it may develop mold.
5. Once deflated, fold the kayak, place in the backpack and store in a dry,
ventilated place above 15°C.
Small holes or punctures can be repaired with the repair kit that is provided
in conjunction with the kayak.
1. Do not inflate the kayak
2. Wipe the hull with soap and water to find holes in the kayak. The soap will
bubble over the hole.
3. Clean the area around the hole with water or alcohol.
4. Use a pencil to sketch out the outline of the patch.
5. Cut a patch of a suitable size.
6. Apply glue evenly to the damaged area and patch and then press and
hold the patch to the damaged area.
7. Leave the kayak for at least 24 hours or more before inflating it.
Valve Replacement
If the valve is damaged, please follow the below instructions for replacing it.
5 www.zraysports.com
Repair
PK6-18-GB(V2)