Wireless Footswitch Operation - Chauvet DJ 4BRATri USB Guía De Referencia Rápida

4BAR™ Tri USB QRG

Wireless Footswitch Operation

1 2
Pedal
1
(Static Colors)
2
(Sound/Strobe Mode)
3
(Blackout)
The 4BAR™ Tri USB footswitch will work properly in any mode, with a maximum
unobstructed distance of 50 ft (15.24 m). You must turn on the rF on the 4BAR™ Tri USB,
set the rF channel, and navigate to Auto mode before using the footswitch.
Footswitch
Battery
Battery
Replacement
The included wireless footswitch provides quick access to preset colors, color-
change programs, and sound-activation through the 4BAR™ Tri USB microphone.
3
To use the footswitch:
1. Connect the 4BAR™ Tri USB to power. Turn the wireless footswitch on.
2. Press <MENU> on the 4BAR™ Tri USB and navigate to rF mode and press
<ENTER>. Choose a channel and press <ENTER>.
3. Press <MENU> on the 4BAR™ Tri USB and navigate to Auto mode and press
<ENTER>.
4. Set the DIP switch channel on the wireless footswitch to match the channel set on
the 4BAR™ Tri USB. (Use the
5. Press pedal #1 (Colors) to activate Static Color controls. When working, all the
lights will begin in a Static color and FOOr will appear on the Menu display.
6.
Use the chart below to activate the desired function.
Action
Tap Pedal to activate, then Tap to
navigate to desired function
Tap Pedal
Hold Pedal Down
Tap Pedal Again
Tap Pedal
Hold Pedal Down
Tap Pedal Again/Hold Pedal Again Turn off Blackout/Fade from Blackout
The wireless footswitch uses a 9-volt battery located under the battery cover on the
bottom of the product, which can be replaced when necessary.
To replace the battery in the wireless footswitch:
1. Turn the power switch to the Off position.
2. Remove the battery cover by removing 2 screws with a Phillips-head screwdriver.
3. Remove the old battery from the housing and unplug it from the leads.
4. Replace with a new 9-volt battery, ensuring that the positive (+) and negative (-) leads
correspond to the correct electrodes on the battery.
5. Place the battery into the housing and cover with the battery cover.
6.
Secure the battery cover with the 2 Phillips-head screws.
Do NOT overtighten the screws!
DIP Switch Channels
Function
White
Red
Green
Blue
Yellow
Magenta
Cyan
Auto Mode (snap)
Auto Mode (fade)
Enter Sound Mode
Strobe Mode
Turn off Strobe (Sound Mode only)
Blackout Fixtures
Fade to Blackout
6
EN
image for help)