Troubleshooting - NVision NV622 Manual Del Propietário

Troubleshooting

Symptom
Battery LED light does not illuminate when
remote buttons are pressed.
Auxiliary lights/equipment not operational when
the remote control button is pressed and the red
LED illuminates.
Some accessories/lights will not come on.
Light/accessory comes on momentarily.
In case the remote is lost, a replacement remote can be paired with the existing module, rather than
purchasing a new system (call customer service at 800-835-0129 for assistance). Pair the new remote
to the main unit before use.
Pairing procedure (See FIG 3): (Caution: Main unit and remote control are already paired when shipped
– call 800-241-3808 before trying to pair a newly purchased NV622 kit).
• Point the remote control towards the main unit and using a small screwdriver press the black
switch. The green light will light up on the powered RCLS unit.
• Now press any one of the four buttons on the remote control to pair the remote with the RCLS.
The green light should turn off indicating successful pairing.
Call customer service at 800-835-0129 for any issues related to your RCLS.
FIG 3
2
Page 4 of 12
Patent Pending
© Copyright 2018
NV622 • REMOTE CONTROLLED LIGHTING SYSTEM • OWNER'S MANUAL
1
Possible Cause and Solution
Remote control battery is dead.
Replace battery (12V A23 alkaline)
1. Vehicle battery voltage below 9.8V +/- 0.3V
DC. Charge battery.
2. Main unit not connected/incorrectly
connected to the battery source. Check
connection and polarity of RCLS.
3. Blown fuse/replace fuse.
4. Pairing between the remote and main unit
disrupted. Pair the system (see below).
Check wire polarity for those items.
That channel is being overloaded. Make sure the
amperage of the light is less than that stated at
the terminal (check fuse).
1 Indicator Light (Green)
2
Pairing Switch (Black)
Hopkins Manufacturing Corporation
Emporia, KS 66801
www.nVisionLighting.com
NVISIONLIGHTING.COM
1-800-835-0129
FIG 3