Operating Instructions
Read ENTIRE IMPORTANT SAFETY INFORMATION section at
beginning of this manual including all text under subheadings
therein before set up or use of this product.
Note: Once Assembly is fully completed, tighten ALL Bolts before initial operation.
Lifting and Lowering
3/4 Ton Load
Figure 9
1.
Locate the hole on the Boom with a weight
limit higher than the weight you will be lifting.
For example: Locate the 1 TON
hole on the Boom for a load that
is under one Ton. See Figure 9.
Bolt
Figure 10
2.
Adjust the Boom Extension
so the hole furthest from the
hook-end aligns with the chosen
hole on the Boom.
Page 8
Nut
Washer
For technical questions, please call 1-888-866-5797.
3.
Secure into place by inserting the
Bolt through all aligned holes and
tightening in place with the Washer
and Nut. See Figure 10.
WARNING! Do not stand under an object
that is being lifted by the Engine Crane.
Be aware of the possibility of a load slipping
off the Hook and Chain. An item that falls
from the Crane can cause serious injury.
4.
Move the Crane so that the Hook and Chain
is directly above the item to be lifted.
5.
Securely attach the Hook
and Chain to the item.
6.
To raise the Boom, turn the Jack's release
valve fully clockwise (right). Insert the
Handle into the Jack and pump (up
and down) repeatedly until the item has
been lifted to the desired height.
WARNING! Be sure to fully tighten the
release valve or else the Jack may lower or
may not be able to reach the full height.
WARNING! DO NOT MOVE THE CRANE WHEN
UNDER LOAD. The Casters are not designed to
be rolled when the Crane is lifting heavy objects.
7.
To lower the Crane, SLOWLY turn the Jack's
release valve counterclockwise (left).
Item 60388
