Assembly
TO PREVENT SERIOUS INJURY AND DEATH: The correct bolts must be used during
assembly. Carefully compare bolts to Bolt Grade Identification illustrations and
the measurements shown in the parts list and assembly diagrams near the end of
this manual to make sure that the correct bolts are used in the correct place.
WARNING! For safety and ease of assembly, use two people to assemble the Shop Crane.
IMPORTANT! DO NOT TIGHTEN ANY BOLTS UNTIL YOU ARE FULLY FINISHED
WITH ASSEMBLY. OTHERWISE PARTS WILL NOT LINE UP PROPERLY.
Base
Figure 1
1.
Slide Legs into front of the Base.
R-Pin
Ring Pin
Figure 2
2.
Lock Legs in place using the Ring Pins.
To insert the Ring Pins, lift up on front
of Base until holes line up. After all
four Ring Pins are inserted, insert one
R-Pin through small hole at end of each
Ring Pin until it snaps into place.
Note: Make sure Ring Pins are
secure before proceeding.
Page 4
Legs
For technical questions, please call 1-888-866-5797.
Bolts
Washers
Figure 3
3.
Use four Bolts and Washers to
fasten the Handle to the Post.
Post
Handle
Item 60388
