Description Of The Appliance; Identification Data; Starting The Appliance - Espressione Cafe Charme 1332 Manual De Usario

Clean only with a non-abrasive cloth that has been slightly dampened with
water, adding a few drops of mild, non-aggressive detergent (never use
solvents that damage plastic).
• Do not place on or near a hot gas or electric burner, or in a heated oven.
KEEP THESE INSTRUCTIONS IN A
•
SAFE PLACE

DESCRIPTION OF THE APPLIANCE

A - Machine body
B - Cup-resting grill
C - Drip tray
D - Power cord + Plug
E - Maxi Cappuccino attachment and wand for water
and steam supply
F - Water tank
G - Filter holder
H - Thermocream® Disc
I - Perforated silicone disc
L - Thermocream® Filter

Identification data

The following machine identification data are shown on the plate found underneath the machine's standing base:
• model (Mod.)
• serial number (SN)
• electrical supply voltage (V) and frequency (Hz)
• absorbed electric power (W)
• assistance toll-free number
Always give the model and serial number to the Authorised Service Centres when requesting assistance.
PRELIMINARy PHASES FOR USE

Starting the appliance

Check that the voltage of the domestic network is the same as that indicated on the technical information plate
of the appliance. Place the appliance on a flat surface.
Before using the appliance for the first time wash the tank. Fill it up with fresh cool water and insert it in its housing
(Fig. 3). Insert the plug into the socket, which must be earthed.
any dripping of water from the small pipe located inside the tank is not to be considered a machine de-
fect, but rather a sign that the self-priming valve is operating normally.
Starting the first time
After having filled the tank with cool tap water, start the machine by pressing the button (O). Indicator lamps (N)
and (S) turn on to indicate that the machine is on and that the internal boiler has started to heat up, respectively.
Press the coffee dispensing switch (R) until you see water come out of the filter holder seat (Fig. 4).
Warning!
If you are starting the machine for the first time or after a period of time during which it has not been used,
it is recommended that at least one cup of water be allowed to pass through the boiler's hydraulic circuit.
Also open the cock (P) by slightly turning it anti-clockwise after having placed a container underneath the
Maxi Cappuccino device wand (E).
Then close the cock (P) by turning it clockwise, and press the coffee dispensing switch (R) to make the water stop
coming out. THE MACHINE WILL BE READY TO MAKE COFFEE WHEN THE INDICATOR LAMP (S) TURNS
OFF.
6
M - Coffee measure/presser
N - On indicator lamp
O - On-off switch
P - Steam dispensing cock
Q - Coffee dispensing indicator lamp
R - Coffee dispensing switch
S - Boiler temperature indicator lamp
T - Steam function switch
U - Pod filter holder
V - Drain pan
W - Pod filter