Complete The Installation - Whirlpool Gladiator GATC26P6WG Instrucciones De Ensamblaje

The Gladiator ® Garageworks Premier 7 Drawer Roll-Away is
■
designed to support a Gladiator
Chest and a Gladiator ® Premier 6 Drawer Chest stacked on top,
as shown on the cover.
Remove the tools from the drawers before stacking and
■
unstacking, and use two or more people to lift the tool
chests.
While using the tool chests, open only one drawer at a time
■
to avoid tipping.
Before moving the Roll-Away cabinet or Roll-Away cabinet
■
stacked with tool chests to a different location, make sure all
the drawers are closed and locked. Use the push handle to
move the Roll-Away cabinet.
Unpack the Cabinet
NOTE: Keep the packing materials to cushion the cabinet during
assembly and then dispose of/recycle all packaging materials.
1. Remove the cabinet, parts and fasteners.
2. Verify contents. See "Parts Supplied."
Install the Bumpers
NOTE: Two of the bumpers are designed to match the contour of the
front of the cabinet and two bumpers are designed to match the
contour of the back of the cabinet.
1. Using two or more people, place the cabinet on its top so that
the bottom of the cabinet is facing up, as shown.
2. Using 6 mm Allen head bolts and washers, fasten a matching
bumper to each corner of the cabinet.
3. Completely tighten all the fasteners.
NOTE: To keep from stripping the bolts, do not overtighten.
A. Bumper
B. Washer
C. Allen head bolt
Install the Casters
IMPORTANT:
Both of the swivel casters with brakes must be installed on the
■
same side of the cabinet.
The swivel casters and the push handle must be installed on the
■
same side of the cabinet.
1. Determine which side of the cabinet you want to install the swivel
casters.
2. Align the holes in the caster plate with the four holes in the corner
of the cabinet.
3. Using four 14 mm bolts and spacers for each caster, fasten the
caster plates to the bottom of the cabinet.
4. Repeat steps 2 and 3 to install the remaining casters.
®
Premier 3 Drawer Intermediate
A
B
C
5. Completely tighten the bolts. Using two or more people, stand
the cabinet upright.
A. 14 mm bolts
B. Swivel caster with
brake
Install the Push Handle
IMPORTANT: Install the push handle to the cabinet so that the
handle is on the same side as the swivel casters.
1. Insert the brackets on each end of the push handle into the slots
on the cabinet side.
2. Align the holes in the cabinet side with the holes in the brackets.
3. Using four 10 mm hex head bolts, fasten the handle brackets to
the cabinet.
B
A
C
D
A. Push handle
B. Handle bracket
C. Slot

Complete the Installation

1. Unroll the drawer liners and place a liner in each of the drawers.
2. Place the pad on the top of the cabinet.
Use, Remove and Replace the Drawers
NOTES:
The key locks the roll-away cabinet and all of the drawers.
■
Use the drawer liners to avoid scratching or damaging the
■
drawer finish.
C. Caster plate
D. Spacer
E
D. 10 mm hex head bolt
E. Washer
A
B
C
D
3