Technical Service; Troubleshooting Chart - Husky KT050003AV Manual De Instrucciones

Ocultar thumbs

Contenido

Tabla de contenido

Operating Instructions

Operation (Cont.)

NOTE: The air shut-off valve (red knob)

does not have to be opened to fill the

tank.

3. Inflate object by locking universal

adapter onto valve stem. Be sure to

press universal adapter down over

valve stem threads completely.

When universal adapter is firmly in

place, press locking lever down to

lock onto valve stem (see Figure 2).

4. Open air shut-off valve by turning

counterclockwise to allow air to

flow into hose.

The tank manifold

WARNING

gauge does not

indicate the pressure in the object

being filled. Use a separate gauge to

check the object.

5. Turn the air shut-off valve clockwise

to the closed position when storing

Troubleshooting Chart

Symptom

Tank loses air pressure

1. Universal adapter

leaks

2. Hose leaks

3. Gauge leaks

4. Manifold leaks

5. Tank leaks

Tank will not hold

enough air

Tank fills slowly

Cannot get air out of

tank

Water in tank

www.chpower.com

the tank to prevent air leaks from

the hose.

Maintenance

Remove accumulated condesation in

tank periodically to prevent rusting.

Hold tank upside down with the

Pressure Gauge

Filler Valve

Safety Relief Valve

Figure 1

Possible Cause(s)

Air leaks

Universal adapter dirty

and not sealing

2a. Hose damaged

2b. Hose connection to

manifold loose

3a. Gauge damaged

3b. Gauge connection

loose

4a. Manifold damaged or

defective relief valve

4b. Manifold connection

loose

Pin hole from internal

rusting

1. Gauge not reading correctly

2. Compressed air source

below 85 psi

1. Fill valve obstructed or

damaged

2. Low volume air output

source

1. Low tank pressure

2. Hose shutoff valve closed

3. Universal adapter damaged

Contaminated compressed air

source

Manifold

Air Shutoff

Corrective Action

Use mild soapy water to locate leak

Clean dirt from universal adapter. Close hose shutoff valve

and replace hose assembly

2a. Replace hose assembly

2b. Remove hose, apply thread sealant and tighten fitting into

place

3a. Replace gauge

3b. Remove gauge, apply thread sealant and tighten

4a. Replace manifold

4b. Remove manifold, apply thread sealant and tighten

Replace tank

1. Check air pressure at fill stem with tire pressure gauge.

Replace gauge if gauge reads differently

2. Locate compressed air source of 85 to 125 psi

1. Inspect opening for foreign material, clean or replace

2. Locate compressed air source of 85 to 125 psi

1. Tank pressure must exceed tire pressure. Increase tank

pressure

2. Turn red knob on manifold counterclockwise to fully open,

1-1/2 turns

3. Replace hose assembly

Hold tank upside down with manifold tilted down. Pull ring on

safety relief valve until air pressure and liquid are fully drained.

Refill with clean, dry air

manifold at the lowest point and use a

low internal pressure to force the

water out through relief valve.