To Assemble The Product; Assembly - Husqvarna BV 30i Manual De Usuario

• If you do not do maintenance, it decreases the life
cycle of the product and increases the risk of
accidents.
• Special training is necessary for all servicing and
repair work, especially for the safety devices on the
product. If not all checks in this operator's manual

To assemble the product

1. Install a beam of the correct width for the operation.
a) Attach the M12 bolts (A) with the square washers
(B) and the nuts (C). The M12 bolts, the nuts and
the square washers are supplied with the
product.
A
F
D
b) Attach the bolts (D) and the washers (E and F) to
the product. The bolts and the washers are
supplied with the product.
c) Torque the bolts to 80 Nm. Torque the bolts
again after the first 30 minutes of operation.
2. Loosen the lock levers to adjust the height position
and the horizontal position of the handles.
3. Tighten the lock levers when the correct operation
position is set.
4. When the handle position is set, pull the lock levers
out. This locks the lock levers to make sure that the
handle position cannot change during operation.
5. Install the user interface cable.
a) Remove the protective cover for the connector
(G) on the product.
1493 - 001 - 27.05.2021

Assembly

C
B
E
are approved after you have done maintenance, turn
to your servicing dealer. We guarantee that there are
professional repairs and servicing available for your
product.
• Only use original spare parts.
b) Remove the protective cover of the user interface
cable (H) and connect the user interface cable.
Make sure that the connector for the user
interface cable is in the correct position.
c) Tighten the locknut (I) fully.
6. Adjust the eccentric weight to the length of the beam
and to the slump of the concrete.
a) Remove the 7 screws and the cover for the
eccentric element.
H
I
9