Control Box; Power Connection - GLÄSS MySpa 226 Manual Del Usuario

Tabla de contenido
Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 46
230 VOLT INSTALLATION
Your spa contains a control box designed to operate at 230V, 60Hz. Installation of a 50 amp.
dedicated circuit is recommended. The control box must be hard wired directly to a sub panel
protected by a Ground Fault Circuit Interrupter (GFCI).
IMPORTANT NOTE: All electrical connections
GB
to the control box must be accomplished by
a qualified electrician in accordance with the

CONTROL BOX

National Electrical Code and in accordance
with any local electrical codes in effect at the
time and place of installation. All electrical
connections must be made in accordance with
the wiring information contained in this manual
and on the back of the field wiring access
panel of the control box.

POWER CONNECTION

To connect power to the spa, refer to "230 VOLT WIRING SCHEMATIC DIAGRAM" and "POWER
CONNECTION ACCESS" illustrations on page 10, then proceed with the following steps: When
supplying power, remove the screws securing the equipment doors (for Utopia and Surround
Sound System spas, always remove the Spa light fixures and lift the fiber optic cable out of
the fixture base before removing the doors).Lower the panel some cm and remove the panel
to allow access to the input power wiring.
NOTE: The 230V wiring diagram is located on the inside of the Control Box Cover.
IMPORTANT: The following must be followed to properly install the equipment compartment
door or pump door.
• Place top of door or panel directly below bar top against the frame of the spa. For Utopia and
Surround Sound System spas, first lift the fiber optic cable out of the way.
• Push bottom of door or panel against the spa frame.
• Slide door or panel upward (pushing in on center of door to ensure door clips catch) until screw
holes line up, makingsure that the exterior LED light cable will fit into the fixture.
• Slightly pull on door or panel, if door remains against the spa then replace the screws.
• If the door does not lock into position, repeat the previous steps.
31
Tabla de contenido
loading

Productos relacionados para GLÄSS MySpa 226

Este manual también es adecuado para:

Myspa 213Myspa 231Myspa 231/213Myspa 226/193Myspa 213/165

Tabla de contenido