Remote control
▶ The flashing will stop when the required temperature is
reached (tolerance from selected set point 5 °F ( 2°C).
Fig. 7
Temperature adjustment
5.3 "Program" button on the remote control
Memorizing the water temperature with the remote control
"Program" button
▶ Press the buttons
8 , [pos. 2]), until the required temperature appears on the
remote control display (Fig.8, [pos. 1]).
▶ You will now be able to memorize this temperature by
pressing the "Program" button on the remote control (Fig.8,
[pos. 3]) for 3 seconds.
Note: Previously saved temperature may
show on the display when first pushing the
program button. Once "PR" shows on the
display, the desired setting will be saved.
Fig. 8
Memorizing water temperature
12
or
on the remote control (Fig.
▶ Only one temperature per remote control can be memorized
using the "Program" button on the remote control.
▶ At this point the remote control will display the memorized
temperature.
When the hot water tap is turned on, the water heater will
supply hot water at the temperature memorized on the
remote control.
Up to six addition remote controls can be
used to memorize a temperature for each
remote control.
Using the "Program" button (operation with memorized
temperature)
To operate the equipment with a previously memorized
temperature:
▶ Press the "Program" button on the remote control.
The remote control display and heater display will now
show the previously memorized temperature. When the
hot water tap is turned on, the water heater will supply hot
water after a few seconds, at the memorized temperature.
5.4 "Priority" function
Temperature cannot be memorized or
changed using the heater's control panel
buttons or a second remote control when
hot water is in use (e.g. during a shower) The
"Priority" function will automatically activate
to stop another user from modifying the
temperature when hot water is in use.
The remote control does not have a default temperature setting
and therefore has no default "Priority" function.The "priority"
will be attributed automatically by the first user who selects or
memorizes (on the remote control or on the heater's control
panel) a temperature for subsequent use (e.g. a shower).
Then, when the hot water is used (e.g. for a shower), the
heater's display and additional remote control displays will
show the symbol "
".
The temperature may only be modified using the same buttons
that set it (depending on whether the control panel or the
remote control was used). The priority device will not have the
symbol "
".
To clear a device that is locked out with the "
(with no hot water running) simply:
▶ press and hold both the "
device for 5 seconds.
The "Priority" function ends:
" symbol
" and "
" buttons on that
6 720 680 078 (2014/06)