Idiomas disponibles
Idiomas disponibles
Electronic siren
Install the siren under the hood, you should put it in a place away from heat and water damage,
while driving through deep puddles or water may be splashed causing damage to the siren, lock it
in a position that water does not damage . If you wash your vehicle engine, protect the siren with a
plastic bag to prevent damage. Damage caused by water or heat are not covered by warranty.
Blink Light
When the siren is sounding, the lights of the vehicle will blink simultaneously. The lights will also
blink when arming and disarming the alarm system.
Codes of the Lights blink
This is a visual indicator of the state of the system of alarm.
1 Flash
Armed
2 Flash
Disarmed
3 Flash
Trunk or Hood opened in armed
4 Flash
When Disarmed indicates that the alarm was trigger.
Sounds Siren
This is a sonorous indicator of the state of the system of alarm.
1 Sound
Armed
2
Disarmed
Sounds
3
Trunk or Hood opened in armed
Sounds
4
When Disarmed indicates that the alarm was trigger.
Sounds
Installation of the warning LED of the board
Locate it in a visible place in the board, the LED illuminates indicating that the vehicle has alarm
system. Indications of the state of the alarm by means of the LED of the board:
Slow flash
Quick Flash
LED Off
1 Flash - 1 Pause
2 Flash - 1 Pause
3 Flash - 1 Pause
continued
When disarming, the siren sounds 4 sounds indicate that the alarm trigger. The LED board by the
flashes will indicate the cause of the trigger. Place a label under the board LED codes indicating.
Valet mode and Button Reset (Function No 1)
Valet Mode is designed to disable the alarm system when required, such as when you need to
leave the vehicle in a parking lot, performing maintenance, etc.
For this mode it is necessary that the alarm system is disarmed, pass the ignition switch in the ON
position, press for 3 seconds the reset button, to activate, the LED board will pass to constant on.
When the alarm system is in valet mode will be excluded engine cuts (anti-hijack) and audible
alarm
To exit valet mode pass the Switch ignition to ON press the reset button for 3 seconds, the LED
board will turn off indicating the valet mode exit.
18
Genius Car Alarm
Genius Car Alarms
Armed system
Rearming automatically, countdown of 90 seconds
Unarmed system and ignition in ON
Alarm Trigger by Door, Trunk or Hood
Alarm Trigger by Shock sensor.
Alarm Trigger by ignition
Alarm in Valet mode
www.alarmasgenius.com
www.geniuscaralarm.com
system
5
