Idiomas disponibles
Idiomas disponibles
Genius Car Alarm
Genius Car Alarms
Introduction.
We thank you for your purchase for your vehicle of our security system. Read through the
operating system use mainly transmitter functions, the switch valet and LED indicator board.
The alarm system OEM-3000 Genius Link, was designed and developed for those vehicles that
have a factory original remote control for opening and closing the door locks
Arming the alarm system.
Arming the alarm system may be obtained by two methods..
The first through the padlock button on the remote control where switch must the ignition is in the
OFF position and the system is not in Valet Mode
The second through Automatic arming, which is obtained by passing the switch ignition form ON to
OFF position and then open and close a door. Automatic system will by armed 30 seconds after
closing the last door. This feature is programmable (see table functions)
Arming the alarm system using the Remote Control.
The alarm system can always be armed by remote control OEM with switch provided the ignition is
in the OFF position and the alarm system is NOT in valet mode.
To arm the alarm system after leaving the vehicle and have closed all doors, simply press and
release the remote control padlock 1 time, the lights will 1 flash, the siren will sound and the LED
on board begins to flash slowly confirming the system is armed, the locks are closed, the current
cuts will be activated preventing the vehicle can be used, after three seconds the alarm system
goes to attempted theft standby mode
Alarm System Arming and triggered.
When the alarm system is armed, the LED on the board flashes slowly, if a door is opened, the
siren began to sound and the lights will flash for 60 seconds if the door remains open after 60
seconds, the siren will continue to sound and the lights flashing for 3 minutes, after the 3 minutes
the alarm system excludes the door sensors and protect the vehicle with the rest of the sensors,
whether the door is closed before the first 60 seconds after starting the siren, the siren is silenced
after 60 seconds and the lights stop flashing.
If to disarm the alarm system, siren sounds 4 times and issued 4 flashes lights, this will indicate
that the vehicle suffered an attempted theft, board LED will flash until the ignition switch pass to the
ON position, please check vehicle.
Disarming the alarm system.
When the alarm system is armed, press and release the unlock button on the remote control OEM,
the siren will emit 2 beeps and lights 2 flashes, indicating the alarm system disarmed, engine cut
be disabled, the LED on the board was turned off, the locks of the doors will open.
Exclusion of defective areas.
When arming the alarm system and some part is defective, the siren will sound 3 beeps and the
lights will flash 3 times simultaneous, indicating that an area is defective when it does the defect
will be excluded automatically and stay protected with vehicle other areas, for example, if the trunk
is not closed at the time of arming the alarm system by transmitter, the siren will emit 3 beeps and
lights flash 3 times indicating that the trunk is not closed and exclude sensors that area. The
defective area will be incorporated into the protection again 3 seconds after the fault has been
corrected after closing the trunk.
www.alarmasgenius.com
3
16
www.geniuscaralarm.com
