Cleaning And Maintenance - Kenmore 758.154200 Manual De Instrucciones

SP6644 6/8/06 8:48 AM
Replacement and Care of Filters
e. Replace the filter housing in the
cabinet.
NOTE: There is a front and back
orientation. To position the filter
housings correctly:
• Be sure that the spring tabs of filter
housings are towards front of
cabinet.
• Align the lower portion of the filter
assembly over the six ribs located
at the bottom rear of the humidifier
cabinet.
f. Position fan assembly onto the
cabinet. Make sure the fan venturi
(lowest cylinder section below the
fan) is placed inside the filter
housing.
g. Replace water bottles.
h. Close the pivoting lid.
i. The unit is ready for use or to be
stored away for next season.

Cleaning and Maintenance

WARNING: To reduce the risk of injury,
fire or damage to humidifier, use only
cleaners specifically recommended for
humidifiers. Never use flammable,
combustible or poisonous materials to
clean your humidifier. To reduce the risk
of scalds and damage to humidifier, never
put hot water in humidifier.
CAUTION: Local water purity varies from
area to area and under certain conditions
water impurities and airborne bacteria
may promote the growth of micro-
organisms in the reservoir of the
humidifier.
To retard bacteria growth that may cause
odors and be harmful to your health, use only Kenmore replacement filters. We
also recommend using EPA approved
bacteriostat, 32-14900 and humidifier
cleaner, 32-14713, available at your local
Sears store.
Page 12
Spring Tabs Towards Front of Cabinet
NOTE: If it is necessary to use approved
bacteriostat, follow directions correctly.
The bottles of the whole house humidifier
will hold 2-3/8 gallons of water each.
Step 1:
To make cleaning easier, the humidifier
cabinet should be empty and completely
dried out. To accomplish this, use the
following method:
a. On the back side of the humidifier
b. Allow the humidifier to run until there is
c. Unplug humidifier.
12
(cont'd.)
Spring
Tabs
Flat Portion of Filter Housing
Towards Back of Cabinet
Step 4e
cabinet, find the float retainer. In
normal operating mode, the retainer
will be positioned in the bottom of the
slot in the cabinet. Push the retainer
up to the top slot position in the
cabinet until it locks in place. (See
"Manual Dryout" section on page 9.)
no water left in the cabinet.
Top
Cover