Hammerhead HCID120 Manual Del Usuario página 15

Destornillador eléctrico compacto y martillo automático
Tabla de contenido
Idiomas disponibles

Idiomas disponibles

OPERATInG InsTRUCTIOns
9. Hammering nails
a. set the dual-function switches
to the auto hammering function
marked with "
b. attach the auto hammer adaptor
to the tool.
c. Position the forward/lock/reverse
selector to either the right or the left.
d. secure the material to be nailed
with clamps to keep it from
turning when hammering.
e. Insert the head of the nail into the
adaptor so that it contacts the
recessed shaft. Place the tip of the
nail against the workpiece.

WARnInG: before depressing the variable-speed trigger to start hammering, make
sure that the adaptor is securely attached on the tool. Otherwise, the adaptor would move,
causing serious personal injury.
f. Holding the shaft of the nail steady with your hand, push down on the tool and press
the variable-speed trigger to initiate the hammering action, and drive the nail just far
enough into the workpiece so that it will stand on its own. release variable-speed
trigger and remove your hand from the nail.

CAUTIOn: be especially careful when driving shorter nails, such as brads, that you
remove your hand as soon as the nail stands on its own in the workpiece.
g. resume pushing down on the tool and pressing the variable-speed trigger to
continue hammering until the nail is fully driven into the workpiece. Near the end
of hammering, the adaptor will retract to allow the hammerhead to drive the nail
head flush to the workpiece.

WARnInG: To avoid possible serious injury, do not exert excessive force on the tool
or apply side pressure. Hold the tool firmly while pushing steadily to allow the hammerhead
to drive the nail automatically.
COMPaCT IMPaCT DrIVEr/aUTO HaMMEr
" .
9
15
Tabla de contenido
loading

Tabla de contenido