Tabla de contenido
Idiomas disponibles
Idiomas disponibles
Wire the Light Control
❒ Remove the existing light fixture.
❒ Install mounting strap to junction box using screws
appropriate for your junction box.
❒ The plastic hanger can be used to hold the fixture
while wiring. The small end of the plastic hanger
can be threaded through the hole in the center of
the cover plate. The small end then goes into one
of the slots on the mounting strap.
❒ Route all fixture wires through the large holes in
the gasket as shown.
❒ Connect the junction box wires to the light fixture
wires as shown. Twist together and secure with wire
connectors.
Mounting
White to
Strap
White
Connect any fixture ground wire(s) and the cover
plate ground screw to the junction box ground
wire.
598-1294-02
Black to
Black
Rubber
Plug
Mounting
Bolt
Gasket
Mount the Light Control
❒ Place the mounting bolt through the front of the
junction box cover. Push the small gasket hole over
the mounting screw.
❒ Make sure the wire connectors and wires are inside
the junction box. Align the mounting screw with the
center hole in the mounting strap. Secure the fixture
to the mounting strap.
❒ Push the rubber plug firmly into place.
❒ If a wet location junction box was not used, caulk the wall
plate mounting surface with silicone weather sealant.
Lamp Shade
Lock Nuts
Keep bulbs at least 2" (51 mm) from the sen-
sor and 2" (51 mm) from combustibles.
❒ Adjust the bulb holders by loosening the lock nuts,
but do not rotate the bulb holders more than 180°
from the factory setting.
❒ Adjust lamp shades by loosening the set screws
several turns, turn shades counterclockwise and
remove. Reinstall the shades in the desired position
and tighten set screws.
3
Set Screw
Tabla de contenido
