Good Earth Lighting G9163-WHX-I Manual Del Usuario página 3

2
Determine the locations where you want the xenon/halogen light(s) to be mounted,
making sure that the cords can reach the next subsequent halogen light (Fig. 2).
Line Transformer
60 in. 120V Line Cord
3
4
You can trace the line voltage (120V) cord along the bottom surface of the cabinet. Do NOT
attempt to conceal the 120V line cord inside your cabinets.
Surface Mounting Installation
Please refer to the MOUNTING PREPARATION INSTRUCTION section for the first three (3) steps
for surface mount installation. This section only explains the mounting of the light fixtures, not
supplying the power to them.
1
OR
2
Skirt
3
4
Mount remaining heads following Steps 1-3. Attach the re-lamping label (included in your
hardware kit) next to one of the heads for future reference when replacing.
Recessed Mounting Installation
Your xenon/halogen lights can be recessed mounted into portable cabinets. Recessed mounting
into fixed kitchen cabinets is NOT recommended. Refer to the MOUNTING PREPARATION
INSTRUCTIONS section for the first three (3) steps for installation.
1
2- / in.
1
8
5,4 cm
2
Fig. 2
Minimum distance between lights
12 in.
30,5 cm
Determine the location where you want the xenon/halogen
light(s) to be mounted, making sure that the transformer
wiring and housing will reach the nearest outlet. Using a
pencil, awl or nail, mark the locations of the screw holes by
holding the light head against the mounting surface as
shown (Fig. 2). Using a power drill, or an awl, put 1 /16 in.
pilot holes in the mounting surface.
Fig. 2
You can trace the low voltage (12V) cord along the bottom
surface of the cabinet or inside the cabinet (Fig. 1). To trace
your low voltage cord inside your cabinets, you must drill an
additional 1/4 in. hole as shown in the illustration. Do NOT
attempt to conceal your transformer or the 120V line cord
inside your cabinets.
Fig. 1
While feeding both wires attached to the reflector cup
Fig. 2
through the housing, hold the reflector cup over the
pre-drilled holes you made earlier in the instructions (Fig. 2).
Using three (3) of the #6 x 1 in. screws (included), secure the
light reflector cup body to the mounting surface as shown.
Route the wires under the notched area of the housing.
NOTE: Make sure your wires are exiting on the side you
want them to. DO NOT install without skirt in place.
Re-attach the lens bezel to the light head by aligning the
Fig. 3
three (3) attachment legs in the cover with the
corresponding openings in the head (Fig. 3). Turn the lens
clockwise to lock it in place. Do NOT operate the
xenon/halogen lights without the lens bezels in place.
Mark the center point you wish the fixtures to be installed.
Fig. 1
Using a hole saw, drill a 2-1/8 in. diameter hole through the
mounting surface (Fig. 1).
Using three (3) of the #6 x 1/2 in. screws, secure the head to
the mounting surface as shown (Fig. 2). Make sure you trace
the wires from the xenon/halogen light through the hole
opening prior to attaching the light to the mounting surface.
12V/Low Voltage Cord
12 in.
30,5 cm
- 3 -
Fig. 2
12 in.
30,5 cm