En - General Instructions For Installation; Important Safety Information - Stell SHO 1029 Manual De Instrucciones

EN – GENERAL INSTRUCTIONS FOR INSTALLATION

IMPORTANT SAFETY INFORMATION

• Check the content of the package in parts list on page 2 and make sure that all parts are in order. Do not
use damaged or faulty parts.
• Read all instructions before installing the equipment. When you are unsure about any part of the
installation process, ask a professional technician for help.
• When tightening the screws, be careful to avoid stripping the thread.
• Do not install on a damp or otherwise damaged wall. The assembly material supplied in the package is
designed to be mounted on a wall of bricks and concrete. For installation on walls made of other materials
consult a professional.
• Never install or use this product if there are signs of damage.
• The edges of the equipment may cause injury if they are handled improperly.
• This device is not designed for assembly or handling by small children, or persons, who have not been
specifically instructed unless supervised by a responsible person to ensure safety during handling or
installation. Children should be supervised to ensure that they do not interfere with the equipment.
Do not allow children to hang on the equipment or otherwise handle it. Otherwise, there is a danger of
serious injury. Never insert your fingers or other objects into the mechanism of the equipment. It could
cause personal injuries or property damage.
• The product contains small parts that can pose a choking hazard when inhaled or swallowed. Keep these
parts out of reach of children!
Note: Specifications and design are subject to change due to improvements without notice.
LIST OF SUPPLIED PARTS
A Mounting plate
B Ceiling plate with tube
C Brackets
D Screw M3×10
E Screw M3×16
INSTALLATION
This projector holder must be attached securely to the ceiling. If not solidly installed, it
could fall and cause injury or damage.
Attachment of the ceiling plate to the ceiling made of bricks or concrete
Mark the position of 3 holes on the wall for attachment of the ceiling plate. Use the plate B as a template
(Fig. 1). Using masonry drill (8 mm) pre-drill holes at least 5 cm deep and insert a plastic anchor M in each.
Make sure that the plastic anchor is entirely inserted and level with the masonry. Attach the holder to the wall
using three screws L, as shown in Fig. 2.
Mounting brackets on the projector
First find the screws suitable for the mounting of the projector (D/E/F/G/H): try to screw them manually
in the openings in the back of the TV set. If you feel resistance stop screwing in immediately! Once you find
the screw with correct threat, proceed according to the drawing 3. Screw the screw into the bracket C and
finally, into the projector. You will need to insert a washer I between the bracket and screw with M3 or M4
thread. Make sure that the screws are vertically aligned.
F Screw M4×12
G Screw M5×12
H Screw M6×12
I Washer M3/M4
J Hexagonal screw M6×16
12 – EN
K Allen key
L Screw M6×40
M Plastic anchor M8×40