Mopar 82209702 Instrucciones Para La Instalación página 9

Note: After connecting all connections through step I, replace the cluster
(4 screws) and then proceed to step J.
LED
J. Drill 9/32" hole in trim panel as
shown in diagram. Exact place-
ment needs to be determined
before drilling. Ensure there is
nothing on the backside of the
panel and there is enough depth for
the LED when the panel is re-
placed. Once drilled, feed the
female connector and LED through
the opening and snap into place.
Route 2-pin harness from main wire
harness to LED mounting location
and mate connectors.
Horn Connection
K. Locate the Dk Green/Violet (X3) wire
in pin #3 of the 6-way white connector
(D2262A) found underneath the
steering column. Center-splice the
harness Dk Green/Violet wire into this
wire, following the center-splice
procedure.
Security Module Connections
L. Connect the 24-way connector into
the PC-12 Security module.
Antenna
24-Way
9