The First Wash Cycle; Technical Data; Electrical Connections - Indesit XWDE 1071481 Instrucciones De Uso

Connecting the drain hose
! We advise against the use of hose extensions;
if it is absolutely necessary, the extension must
have the same diameter as the original hose and
must not exceed 150 cm in length.

Electrical connections

Before plugging the appliance into the electricity
socket, make sure that:
• the socket is earthed and complies with all
applicable laws;
• the socket is able to withstand the maximum
power load of the appliance as indicated in the
Technical data table (see opposite);
• the power supply voltage falls within the values
indicated in the Technical data table (see
opposite);
• the socket is compatible with the plug of the
washer-dryer. If this is not the case, replace
the socket or the plug.
! The washer-dryer must not be installed
outdoors, even in covered areas. It is extremely
dangerous to leave the appliance exposed to
rain, storms and other weather conditions.
! When the washer-dryer has been installed, the
electricity socket must be within easy reach.
! Do not use extension cords or multiple sockets.
Connect the drain
hose, without bending
it, to a drainage duct or
a wall drain located at a
height between 65 and
100 cm from the floor;
alternatively, rest it on
the side of a washbasin
or bathtub, fastening
the duct supplied to
the tap (see figure).
The free end of the
hose should not be
underwater.
! The cable should not be bent or compressed.
! The power supply cable must only be replaced
by authorised technicians.
Warning! The company shall not be held responsible
in the event that these regulations are not respected.

The first wash cycle

Once the appliance has been installed, and before
you use it for the first time, run a wash cycle with
detergent and no laundry, using the wash cycle
"Auto Clean" (see "Cleaning the washer-dryer").

Technical data

XWDE 1071481
Model
width 59.5 cm
height 85 cm
Dimensions
depth 60.5 cm
from 1 to 10 kg for wash
programme
Capacity
from 1 to 7 kg for the drying
programme
Electrical please refer to the technical
connections data plate fixed to the machine
maximum pressure
1 MPa (10 bar)
Water con-
minimum pressure
nections
0.05 MPa (0.5 bar)
drum capacity 71 litres
up to 1400 rotations per
Spin speed
minute
wash: programme 11; tem-
perature 60°C; using a load
of 10 kg.
drying: the smaller load
Energy ra-
ted (3kg) must be dried by se-
programmes lecting the "
according to vel. The load must consist of
regulation 3 sheets, 2 pillowcases and
EN 50229 1 hand towel; the remainder
of the load must be dried by
selecting the "
level.
This appliance conforms to
the following EC Directives:
- 2004/108/EC (Electroma-
gnetic Compatibility)
- 2006/95/EC (Low Voltage)
- 2012/19/EU (WEEE)
GB
" dryness le-
" dryness
3