Operation - Husky HV02000 Manual Del Usuario

SP6689-2 Husky HV0200_ES.qxd
WARNING: To reduce the risk of fire, explosion, or damage to Vac:
!
• Do not leave Vac running while unattended - you may fail to notice important
signs indicating abnormal operation such as loss of suction, debris/liquid exiting
exhaust, or abnormal motor noises. Immediately stop using Vac if you notice
these signs.
• Do not leave Vac plugged-in when not in use.
• Do not continue running when float has cut off suction.
• Do not operate Vac in areas with flammable gases, vapors or explosive dust in
the air. Sparks inside the motor can ignite airborne flammables. Flammable
gases and vapors include: lighter fluid, solvent-type cleaners, oil-based paints,
gasoline, alcohol, or aerosol sprays. Flammable dusts include: coal, magnesium,
aluminum, grain, or gun powder.
• Do not vacuum up explosive dusts, flammable liquids, or hot ashes.
• Do not use Vac as a sprayer.
WARNING: To reduce the risk of electric shock or injury:
!
• Do not expose to rain or allow liquid to enter the motor compartment. Store indoors.
• Do not handle plug, switch, or Vac with wet hands.
• Do not service Vac while it is plugged-in. If your Vac is not working as it should, has
missing parts, has been dropped, damaged, left outdoors, or dropped into water,
return it to an independent service center or call customer service.
• When using an extension cord, use only outdoor-rated cords that are in good
condition. Do not allow the connection to come into contact with liquid.
• Do not vacuum toxic materials to reduce the risk of inhaling the vapors or dust.
Your two and a half-gallon wet/dry vac is
assembled at the factory and ready for
use when you remove it from the carton.
The unit is ready for dry vacuuming or
blowing. After you plug the power cord
into the wall receptacle, turn the unit "ON"
by pushing the switch from position "O"
to position "I". The symbols used on the
switch are international symbols. The "O"
is the "OFF" position and the "I" is the
"ON" position.
= OFF
4/18/08 3:48 PM

Operation

"I" - "ON"
Position
= ON
7
Page 7
"O" - "OFF"
Position