Tabla de contenido
Idiomas disponibles
Idiomas disponibles
If a fault occurs, first check the points listed below before taking the set for repair. If you are unable to remedy a problem by
If a fault occurs, first check the points listed below before taking the set for repair. If you are unable to remedy a problem by
following these hints, consult your dealer or service center.
following these hints, consult your dealer or service center.
WARNING:
WARNING:
Under no circumstances should you try to repair the set yourself, as this will invalidate the
Under no circumstances should you try to repair the set yourself, as this will invalidate the
warranty.
warranty.
PROBLEM
– POSSIBLE CAUSE
• REMEDY
No sound
– Volume not adjusted
• Adjust the VOLUME
Display error/ no reaction to any controls
– Electrostatic discharge
• Press RESET
Occasional crackling sound during FM broadcast
– Weak signal
• Adjust the position of the power cord
Continuous crackling/
hiss disturbance during AM broadcast
– Electrical interference from TV, computer, fluorescent lamp,
mobile phone, etc.
• Move set away from other electrical equipment
The alarm does not function
– Alarm time/mode not set
• See SETTING THE ALARM
– Volume too low for ALARM 1-RADIO
• Adjust the volume
– ALARM 1-RADIO not tuned to a radio station
• Check if the set is tuned to a radio station before setting
the ALARM 1-RADIO, and when switching off
TROUBLESHOOTING
11
Tabla de contenido
Solución de problemas
