Troubleshooting - Hkoenig KB14 Manual De Utilización

TROUBLESHOOTING ：
Please note, if a power failure occurs due to disconnection of the power cord, or the power
1.
button has been pushed off during an ice making cycle, small ice chips may formed and lodge
in the automatic shovel causing it to jam. If this occurs, the ice chips may be removed by
disconnecting the power cord and gently pushing the shovel to the rear of the cabinet and
removing the ice chips, then restarting.
Please check if the water reservoir is flat when the ice shovel can not remove the ice to ice basket.
2.
If not, please push the ice shovel gently by finger, then press POWER button to restart.
PROBLEM
The compressor
works abnormally with
a Buzzing
Noise
Water shortage
indicator
light is on
Indicator lights on
display are not on
The Ice made is too
large
and with pieces
sticking
together.
All indicators twinkle
simultaneously
WARNING
Fill with potable water only.
It is normal for the compressor and condenser surface to reach temperatures between 70°C and
90°C during operation and surrounding areas may be very hot.
Due to fast freezing, ice cubes may appear "Cloudy". This is air trapped in the water and will not
affect quality or taste of ice. Do not immerse in water.
Warning –keep ventilation openings, in the appliance enclosure or in the built-in structure clear of
obstruction.
Warning – do not use mechanical devices or other means to accelerate to defrosting process, other
than those recommended by the manufacturer.
Warning – do not damage the refrigerant circuit.
Warning – do not use electrical appliance inside the food storage compartments of the appliance,
unless they are of the type recommended by the manufacture.
POSSIBLE CAUSE
The voltage is lower than
recommended
1.There is no water
2.The pump is full of air
Blown fuse/ No power
1.water temperature is too
low
2.Ice of previous cycles
left in the water tray
Water tray is blocked by
ice cube
SUGGESTED SOLUTIONS
Stop the Ice maker and do not restart until
the voltage is normal.
1.Add to some water until it reaches MAX
position
2.Press POWER button to restart
Replace fuse / Turn power on
1.Select small size
2.Take out the ice under the standby state
Unplug the power to take out the ice
which blocking the tray, then plug the
power and press the POWER button, the
machine will restart 3mins later.