Jean Louis David JLD-201 Manual De Instrucciones página 9

seal), see FIG 2.
STEP 4 : Fill the water as shown in FIG 3.
Replace the black rubber seal and ensure it
is secured (should you overfill wipe off any
excess water with a clean cloth).
STEP 5 : Put the water tank back on top of
the Vapor Styler as shown in FIG 4. On the
top of the water tank you will see an arrow.
Line this arrow with the other arrow that
is on the Vapor Styler. Insert the tank on
a slight angle with the arrow in first. Once
lined up, click/press into position. See FIG
5. You will hear a click when it is properly
in place.
STEP 1
PULL THE UNLOCK BUTTON
RELEASE THE WATER TANK
STEP 3
PULL BACK THE BLACK
RUBBER SEAL AND FILL IN
STEP 5
STEAM SETTING
(OFF/MED/HIGH)
STEP 2
RELEASE THE WATER TANK
STEP 4
INSERT THE WATER TANK
INSIDE (FOLLOW DIRECTION
OF THE ARROW)
STEP 6
ON/OFF,
HEAT UP/DOWN BUTTON
9
FIG. 3
FIG. 4
FIG. 5