Idiomas disponibles
Idiomas disponibles
User Manual
First time start.
Press the button for a few seconds until the green light turns on and
stays fixed.
Standby mode options.
A) To RECORD hold the button for 2 seconds and the light will start
flashing on and off during the recording. If you press the button, the
video is saved, it stops recording and turns on the light in standby
mode.
B ) To make PHOTOS, each time you press the button it will take a
photo and then go on to Standby mode.
Turn off.
Hold down the button for about 5 seconds until it shuts off. If you do not
use the pen for approximately 30 seconds, it will automatically enter
standby mode to save battery.
Changing time.
A) Reset the pen ( click on the reset hole with a pin or similar for 4 sec.).
Turn on your PC and open the WINDOWS NOTEPAD .
B ) Create a txt file named "time.txt" and type in the file the current date
and time in this format only : 2018.03.01 23:12:00 .
C ) Connect the pen to the PC and copy the file created earlier to the
root directory of the memory card. In the next recording the correct
time and date will appear and the file will disappear.
Recommendations.
A) Before using the pen for the first time, connect it via USB to the PC
to charge completely the Lithium battery for 12 hours (also for the first
three charges ) and the following for about 4 hours.
B ) Insert a micro -SD card in the slot after the charging is completed .
The pen will stop and turn off when the storage capacity and / or battery
is exhausted or until you press and hold for total shutdown.
C ) If the pen locks again reset it pressing the reset button for 4 sec-
onds.
D ) No drivers are needed because the system recognizes it as an USB
4
english
