Rehaforum MEDICAL Actimo Premium Manual Del Usario página 7

Instructions / Assembly
1. Remove the walker from the box and check
the contents and the packaging for damage
or completeness.
The rollator is assembled and supplied in
folded form in a cardboard / plastic bag.
2. Place the Actimo Premium flat on the floor
and unfold it by pulling the handles. The
oval plastic holder and the frame tube
must be inserted together completely
before the locking lever is closed (figure 1).
3. For fixing, pull the locking lever from the frame on both the sides (Figure 2) and rotate it 180°
until it points forward. Make sure that the handle tube is upright and that the plastic holder
firmly locks into position in the frame. The washer must sit correctly at the end of the locking
lever. Now turn it around 180 degrees until it is parallel to the frame and then press the lever
in the appropriate slot (Figure 3). Make sure that you do not press the locking lever too
tightly before the handle tubes are not sitting firmly on the frame in order to avoid damage!
Fig. 1
4. Then you open the clip on the side of the seat and press down the seat surface with the palm
of your hand. Now the Actimo Premium is completely unfolded. Check whether the seating
surface has fully fit into the plastic holders. Check on the outer sides whether the frame is
securely connected to the plastic holders.
5. Adjust the handles at waist height, so that the arms are
flexed by about 20 ° -30 ° while sliding. Loosen the knob
screw at the tube holder, push or pull the handle tube to the
desired height (holes for fixing) and tighten the knob screw
again. Ensure that the handles are at the same height and do
not pull the entire grip tube from the frame when adjusting
it!
Fig. 2 Fig. 3