HAMPTON BAY 7107-03 Guía De Uso Y Cuidad página 7

Installation - New Construction (continued)
Securing suspensions brackets onto fan
4
housing
 Secure suspension brackets (G, H) to the fan housing (A)
using the two machine screws (D) and secure suspension
bracket (F) to the other side of housing using the short
machine screw (E).
5
Removing wiring cover on the fan housing
 Remove the wiring cover. Pull the house wires through the
wire box cover hole (5.1). Using the quick connector, secure
120 V AC house wiring from the wall switch to the fan as
shown in the wiring diagram on page 3. 14 AWG is the small-
est conductor that should be used for branch circuit wiring.
 Carefully push the connected wires back into the wiring box
housing. Reattach the wiring box cover (5.1).
If the electrical wires do not match the colors
CAUTION:
listed, you must determine what each house wire represents
before connecting. You may need to consult an electrical
contractor to determine safely.
6
Connecting the duct
 Connect a 4 in. circular duct (not supplied) and vent to the
outside. Secure it with duct tape (not supplied) or a clamp (not
supplied) to make the connection secure and air tight.
 Turn on the power source. Check the fan for any abnormal
sound or vibration.
7
Installing the grille
 Attach the grille (B) by pinching the mounting springs and
inserting into the narrow rectangular slots in the fan housing (A).
F
E
G, H
House
Wires
5.1
A
7
Please contact 1-855-HD-HAMPTON for further assistance.
Quick
Connector
Product
Wires
HAMPTONBAY.COM
D
A
B