Tabla de contenido
Idiomas disponibles
Idiomas disponibles
6)
Before the dispenser leaves the factory, the cold water thermostat is properly set. Do
not adjust the thermostat.
7)
When bottle is empty, vertically pull it out by two hands, and then replace it with
another bottle.
8)
The spilled water in the drip tray must be removed regularly and cleaned properly. To
remove it, slide tray out.
9)
In case hot or cold water is not needed for an extended period of time, turn off the
switch accordingly to save power.
NOTICE: To prevent damage to dispenser, do not turn cold water switch back on
within 3 minutes of having turned it off.
PROPER CARE AND CLEANING OF DISPENSER_____________________
WARNING: SHOCK HAZARD. Unplug the water dispenser before cleaning.
Cleaning the Outside and Storage Compartment:
IMPORTANT: Set both power switches (on the back of the dispenser) to the OFF position and
unplug the water dispenser before cleaning.
The inside and outside of the cabinet can be washed with mild soap and water. Rinse thoroughly
with clear water. Never use commercial cleaners or abrasive scouring powders.
Sweep away or vacuum any dust from the condenser coils on the back of the unit. For best results,
use a brush specially designed for this purpose. It is available at most appliance stores.
Cleaning the Inside of the Storage Compartment:
For prevention of odor, place an open box of baking soda in the storage compartment.
IMPORTANT: Set both power switches (on the back of the dispenser) to the OFF position and
unplug the water dispenser before cleaning.
Use a solution of warm water and baking soda (approximately one tablespoon of baking soda to
one quart of water). This will clean and neutralize odors. Then rinse and wipe dry.
Other parts of the storage compartment including door gaskets and plastic parts can be cleaned in
the same manner.
________ Drip Tray Grille
________Drip Tray
8
Tabla de contenido
