Celestron 44421 Manual De Instrucciones página 3

setting Up Your Digital Microscope imager
1. Carefully remove the Imager, Adapter, and CD-ROM (Digital Microscope Suite)
from the box and set them on a table, desk, or other flat surface. The USB cable
is permanently attached to the Imager.
2. Remove the plastic bag covering the Imager.
3. The Adapter (image below) will attach to the Imager with three thumbscrews.
First back up the threads from the Adapter so they do not protrude through the
barrel so there is no interference when inserting the Imager and then insert it.
A. The position of the Adapter on the Imager
is not critical but the top of the adapter
(thumbscrew end) should be about 40 mm (1.6")
from the sensor end for optimal performance
on most microscopes. Tighten the screws.
4. Remove the eyepiece (just one eyepiece if your microscope
uses two eyepieces as with a stereo microscope or binocular
head with a biological microscope).
5. Put the Imager into the eyepiece barrel. It is held in place by
its own weight and this is ok. However, when moving your
microscope with the Imager in the eyepiece barrel, do not
turn the microscope sideways or upside down or the Imager
will fall out.