Led Indicators And Troubleshooting; Operating/Service Led; Supply Voltage Led - Weidmuller EPG CUT 40 Manual De Instrucciones Original

6

LED indicators and troubleshooting

In case of any fault, the tool will be switched
off and remain disabled. The service LED will
glow red or orange. You can proceed with
your work only after the battery has been
exchanged or removed for short time and is
then re-inserted (reset).
6.1 Operating/service LED
LED-Display Cause
After battery insertion
green (2 seconds) The tool is ready for operation.
steady orange The temperature is outside the tolerance range. ► Cool or warm the device.
steady red The battery is empty.
After application (cycle)
green (2 seconds) Procedure successfull, the working value is OK.
steady orange The temperature is outside the tolerance range. ► Cool or warm the device.
flashing red The working value is at the limit.
steady red The working value is outside range.
The working value is OK but the service interval
flashing red/green
is exceeded.
6.2 Supply voltage LED
LED-Display Cause
After battery insertion
steady green The tool is ready for operation.
steady red The battery is empty.
After application (cycle)
flashing red The battery charge is below 10 %.
steady red The battery is empty.
steady red The working value is outside range.
The working value is OK but the service interval
flashing red/green
is exceeded
2516410000/03/07.2019
If the malfunction persists even after such
a reset, please contact the Weidmüller af-
ter-sales service.
Recommended action
► Change the battery.
► Contact the service centre.
► Return the tool to customer service.
► Authorise the service
Recommended action
► Change the battery.
► Change the battery.
► Change the battery.
► Return the tool to customer service.
► Authorise the service
27