Bushnell ImageView Manual Del Usuario página 3

QUICK START GUIDE: BUSHNELL IMAGEVIEW SPOTTING SCOPE 111545
1) To use the ImageView as a standard spotting scope, attach it to a tripod (a small one is included), set the slider (F) to
the "Eyepiece" position, and look through the eyepiece (the rubber eyecup may be rolled down if you wear glasses). The
eyepiece diopter adjustment (J) index dot should be set to the "0" position. Aim the scope at your subject and adjust the
focus knob (O) until it appears sharp. The eyepiece zoom (N) may be set to any magnification desired from 15x to 45x
power. Readjust the focus if you start at low power and zoom up to a higher setting.
2) To set up the digital camera, insert two AA batteries (not included) into the compartment (I), noting the polarity marks.
Plug the included remote shutter cable into the jack (K) to prevent jarring the scope when taking photos. The ImageView
scope has internal memory that will hold about 15 photos (at the default 5MP resolution). However, the internal memory
contents may be lost if the batteries are removed or get very weak during storage, and you may prefer to use an SD card
for its much greater storage capacity. Insert your SD card (face up, notch on right) in the slot (M). The card will click into
place. Push the card in slightly to remove. You may use SD cards (avoid using MMC cards) up to 4 GB capacity. Raise the
LCD display (G), and press the ON/OFF button (A) briefly – the Power LED (H) will light. If the SD card you inserted was
previously used in other devices, format it before taking photos. Note that this will erase all files on your card (or the
internal memory if no card is present) – make sure you have backed up any files you wanted to keep. Press the MODE
button (B) to enter the Capture menu (Fig. 1), then press the SNAP button (E) to enter the Set up menu (Fig. 2). "Format" is
the first option – press the OK button (D), then the Down arrow key (C) to select "Execute", and press OK. Press the MODE
button to exit all menus.
3) When you are ready to take a photo, switch the slider (F) to "Camera". Note: your photos will be all black if the slider is left
in the Eyepiece position. The internal camera provides a fixed magnification of about 22x – this corresponds to what you
see through the eyepiece with the zoom ring set to the green dot position (lined up with the red index dot). Adjust the
focus knob if necessary so the subject appears sharp on the LCD. Press the button on the remote shutter cable to take the
photo. It is also possible to shoot video movies (VGA, 20 fps) with the ImageView scope. Press and hold the SNAP button
for 2-3 seconds, then release. A movie film icon appears in the display at top left. Press the remote shutter button to start
recording. A counter at the bottom of the display shows elapsed time. Hold the SNAP button down for a few seconds again
to return to still photo mode. The camera will automatically turn itself off after three minutes of inactivity (this can be
changed with the "Auto Off" options in the Setup menu – see the online full user's manual for more information).
English
3