Mestra KOALA Manual Del Usuario página 10

English
Koala Vacuum Mixer (R-080520) makes
mixing of investment, plaster and related
mixtures easy.
possible to choose among three different
operational modes:
"Vacuum" Operational Mode. With this
•
option, the Mixer will run a vacuum
without mixing cycle that will last the time
selected on the display. It is a very
practical mode when soaking the master
models in vacuum atmosphere. Vacuum
time can be chosen from 5 seconds up
to 99 min. 59 sec. This mode is activated
when the "Vacuum"
switched on.
"Mixing" Operational Mode. Similar to the
•
previous one, but in this case mixing
blades operate while vacuum pump is
off. Mixing time can be adjusted from 15
seconds up to 10 min. Every 10 seconds
operating in this mode, mixing motor
makes a kickback in order to obtain an
even mixing. When this mode is option, it
is necessary to have a fastening arm (R-
080522) that can be purchase as
attachment (consult
distributor), because as vacuum is not
operative, the bowl is not fastened to the
mixer nozzle.
"Vacuum+Mixing"
•
Similar to the previous ones, but in this
mode vacuum pump and mixing motor
run simultaneously. Time can be chosen
from 15 seconds up to 10 min. The
machine makes a kickback working this
way.
The Mixer also allows programming up to 3
different operational
machine run. For optimum performance and
a long lasting life, please read the following
instructions.
INSTALLATION
1. Carefully unpack the KOALA Mixer.
2. Check that in the packaging you find the
following accessories:
A 250 cc mixing bowl (G).
•
A 550 cc mixing bowl (H).
•
10
This machine makes
Icon Light
your MESTRA
Operational Mode.
modes for
GB
A wall anchoring kit.
•
An Allen spanner for fixation flanges.
•
Plastic spatula for plaster-alginate (R-
•
060002).
3. Choose a wall far from heat sources,
vibrations
necessary that this were a firm, rigid and
well-levelled surface.
4. Place the tie down flat bar in the chosen
place at a suitable height for working.
Make sure this point is horizontal lined
perfectly. Then, mark the screw holes on
the wall with a marker.
5. Drill the mentioned marked holes with a
is hand-held drill and a 10 mm. widia drill.
6. Fit the nylon rawlplug plug included in
the mixer anchoring kit. Place the tie
down flat bar on the wall and fix it firmly
using the screws from the kit.
7. Mark on the wall 2 vertical lines at 75
mm from each end of the tie down flat
bar. These marks will help you to centre
the Mixer.
8. Remove the 2 fixation flanges from the
back lower side of the machine. Place
the machine on the tie down flat bar.
Make sure it is well centred taking into
account the marks done. Put the fixation
flanges again. Make sure flanges are
correctly placed on the tie down flat bar.
9. Thread the flanges screws till the
machine is securely fastened.
10. Connect the Mixer mains cable to 230 V,
50/60 Hz equipped with earth return.
HOW TO USE THE MIXER
Once the installation is finished, the Mixer is
ready to be used:
each 1. Activate the Mixer master switch (D).
After some seconds the indicator light of
the last selected mode will light and the
display
programmed time.
2. Press the selection key (7) to choose the
machine operation mode. With each
pulsation, you will find that the light
corresponding to each of the modes will
light (8), (9) and (10) (Mixing, Vacuum
and Vacuum+Mixing).
or moisture. It
(1) will show
is also
the last