Recharging The Battery - Seac R3-R3FX Instrucciones

PRE-DIVE INSPECTION
• If your torch has not been used recently, check the condition of the
batteries by ensuring that it switches on.
• Check that the body is fully closed.
• As soon as you enter the water, check that no bubbles emerge from
the body of the torch.

RECHARGING THE BATTERY

Pay the utmost attention to ensuring that there are no flammable
objects or products near the battery while it is charging.
• Unscrew the end cap counter-clockwise (where the strap attaches).
• Pull the battery out of the torch body.
• Insert the battery in its seat in the battery charger, taking care to
match the polarity direction shown on the battery charger and the
battery itself. They must always match.
• Plug the micro-USB cable connector into the port on the charger
and connect the other end to a 5-Volt, 1-2 Amp power adapter. A red
LED will turn on immediately on the top of the battery charger, on
the micro-USB port side. This indicates that the battery is charging.
When the battery is fully charged the LED will turn green or turn off.
Unplug the connector plugged to the power adapter or computer
USB port first, and then unplug the micro-USB connector from the
charger.
Avoid leaving the battery connected to the power once it is
charged, and in any event not longer than a few hours. Failure to
do so could cause damage to the product and pose a danger to
people and/or things.
FLOODING
If water gets into the torch, open the body, remove the battery, and
immediately rinse the internal parts in fresh water. Then dry everything
with a cloth and a hair dryer using warm air, paying close attention
867-manuale Seac torce serie R3 R3FX.indd 15

WARNING

WARNING
R3-R3FX
15
18/09/2018 10:00:18