Denon Professional Envoi 2 Guia Del Usuario página 5

Operation
Installing the Envoi Receiver 2 Module
To install the Envoi Receiver 2, follow these setup steps:
1. Make sure the power cable is disconnected and
Envoi is powered off.
2. Remove the two screws on the top right Envoi
Receiver blank plate covering the compartment
using a mini-screwdriver, type 000 (see figure
1).
3. Find the two ribbon cables grouped together
in the panel compartment and remove the clip
holding the cables together (see figure 2).
4. Connect the cable with red, gray, and black wires
to the top of the board on the Envoi Receiver 2
(see figure 3).
5. Connect the smaller cable with the gray wire to
the bottom of the board on the Envoi Receiver 2
(see figure 4).
Note: Make sure not to attach the cables
backwards.
6. Gently tuck the cables under the board and slide
the Envoi Receiver 2 downward into the panel
(see figure 5).
7. Attach the two screws to the Envoi Receiver 2
panel.
Figure 1
Figure 2
Figure 3
Figure 4
Figure 5
5