4.2.3 Installation on flush-type box
The fixing holes in the mounting plate can be used for installation onto a flush-type
box.
1. Remove the mounting plate from the room control unit Display S.
2. Align the mounting plate horizontally on the flush-type box.
3. Install the mounting plate with the correct screws (see Q in fig. 2).
4. Install the interchangeable frame onto the mounting plate.
5. Position the device onto the mounting plate and latch it into the clips.
4.2.4 Installation in multiple combinations
The device can be used with frames of other manufacturers or be integrated in a
multiple frame. For installation in multiple combinations, install the mounting plate
of the device flushing with the already installed mounting plates/bearer rings and
align it to these. The device will fit into the frames of the following manufacturers:
Manufacturer
Berker
ELSO
GIRA
merten
JUNG
Frames
S.1, B.1, B.3, B.7 Glass
Joy
System 55, Standard 55, E2, E22, Event, Esprit
1-M, Atelier-M, M-Smart, M-Arc, M-Star, M-Plan
A 500, AS 500, A plus, A creation
Commissioning
21