GYS FLASH 10.36/48 PL Traducción De Las Instrucciones Originales página 9

Translation of the original instructions
Acid projection hazard !
• Wear safety goggles and protective gloves
• If your eyes or skin come into contact with battery acid,
rinse the affected part of the body with plenty of water and
seek immediate medical assistance
Connection / disconnection :
• Ensure that the charger's power supply is disconnected
before connecting or disconnecting to the battery terminals.
• Always ensure the Red clamp is connected to the ""+""
battery terminal first. If it is necessary to connect the black
clamp to the vehicle chassis, make sure it is a safe distance
from the battery and the fuel/exhaust pipe. The charger
must be connected to the mains.
• After charging, disconnect the charger from the mains,
then disconnect the negative clamp from the car body and
then disconnect the positive clamp from the battery, in this
order.
Connection :
• Class I device
• This device must be connected to an earthed power
supply
• The connection to the power supply must be carried out
in compliance with national standards.
Maintenance :
• If the power cable is damaged, it must be replaced by
the manufacturer, its after sales or by an equally qualified
person to prevent any accidents.
• Service should be performed by a qualified person
• Warning! Always remove the power plug from the wall
socket before carrying out any work on the device.
• Under no circumstances should solvents or other
aggressive cleaning agents be used.
• Clean the device's surfaces with a soft, dry cloth.
Regulations :
• The Machine is compliant with European directives.
• The declaration of conformity is available on our
website.
• EAEC Conformity marking (Eurasian Economic
Community).
GYSFLASH 10.36/48 PL EN
9